Boulder 1021 Owner's Manual download pdf (Page 37)

9-2

A hand-held infrared remote control is included with the 1021. This

remote control is machined out of aerospace-grade aluminum and

is heavy. Please be careful not to drop the remote on furniture or

ooring.

If you notice that your remote control seems not to be working

properly, the batteries are probably low. Check the batteries

periodically and replace them before they are “dead.” Fully

discharged batteries are prone to leaking and may cause damage

to the remote control.

Installing the Batteries in the Remote Control

The 1021 Remote Control is powered by three (3) AAA batteries. To

install or replace batteries in the remote control, it is necessary to

separate the two halves of the remote housing.

Note: When opened, the remote’s pushbutton balls will not be held

securely in place and care must be taken so that they are not lost!

Laying the remote control 1. face down on a at surface so that

the balls will stay in position is strongly recommended.

Using a #3 at-blade screwdriver, remove the three (3) screws 2.

that secure the rear panel of the remote control.

Install the three (3) batteries with the positive (+) terminals 3.

facing as indicated on the battery holder.

Replace the cover and reinstall the three (3) screws. 4.

The remote of the 1021 features all of the commands necessary to

operate any function of the 1021. The following commands are

included on the remote. Unless otherwise noted, the Remote Control

operates exactly the same as the Front Panel Buttons.

Remote Control

Remote

Control

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 97 98

No comments

Boulder 1021 Owner's Manual Page 37